Liquid-Foot +

Examples

2 Buttons controlling 1 Expression Pedal Port.
Wizard programming Axe-Fx II.

2 Buttons controlling 1 Expression Pedal Port.

It's possible to use two Buttons on one Expression Pedal. I personally use only one Expression Pedal and 6 Buttons connected to the other 3 Expression Pedal ports. Here's how you do that!

First of all you need some special wiring like the schematic below. Beside jacks and buttons, you only need some very cheap resistors.

Then you navigate to Settings Global Features in the Editor (e.g. Pedal#4)

Set Pedal# to 2 Page Buttons. 1st button to the first Page Button you want to control with the first physical Button
and 2nd button to the second Page Button you want to control with the second physical Button.

It's a good advice to choose Page Buttons which are not physical Buttons on your pedal board.
Personally I took page Buttons 55-60 for controlling my 3 Expression Pedal ports.

Since these are Page Buttons they have 2 big advantages:
- You can have 2 Functions on each Button.
- Every Button can be a different Command on a different Page.

Don't forget to calibrate your Buttons!
You could use the auto calibrate in Settings Global Features, but then you need to push all Buttons on every boot because the first time both buttons will trigger the 1st Button.
It's better to calibrate it once on the hardware.

Push Button 2 and 3 at the same time to enter the GLOBAL MENU.
Push MENU > untill you see Global on the Main LCD.
Push Select.
Push MENU > untill you see Select EXP Pedal on the Main LCD.
The second line will show 1, the selected expression pedal.
Push PARAM > untill you see EXP Calibrate on the Main LCD.
The second line will show a status bar.
Move expression pedal or push both buttons several times (e.g. button 1 1 2 2 1 1 2 2)
Push SAVE.
Push PARAM < untill you see Select EXP Pedal on the main LCD.
Push PARAM ^ to change the selected expression pedal.
Repeat steps above untill done.
Push EXIT twice when finished.